Eleaf iStick T80 80 W mod with built-in battery

Built-in power for your atomizer

The Eleaf iStick T80 combines a 3000 mAh battery with adjustable output up to 80 W. This listing is for the mod only, without an atomizer. It suits a setup where you want to adjust the heat while keeping a battery that recharges directly inside the device.

Set the wattage to suit the coil

The 80 W maximum is the mod’s output limit. To choose your setting, start with the range recommended for the installed coil. Begin at the lower end and increase gradually, after allowing the cotton to absorb e-liquid. Check your choice of atomizer before fitting it.

Size and charging

The body measures 78 × 36 × 28 mm. These measurements describe the mod; the atomizer you add will determine the height of the complete setup. A USB-C cable and user manual are supplied with the iStick T80.

To charge, connect the cable to the USB-C port and follow the manual’s instructions. Keep this port clean and dry, and avoid pulling on the cable while it is plugged in. Before changing atomizers, turn off the mod and wipe its connection area to prevent traces of e-liquid from building up there.