Vaporesso GEN SE 80 W mod for an 18650 battery

A Vaporesso mod using a separate 18650 battery, adjustable from 5 to 80 W. Its AXON chip runs Pulse mode, with a TFT screen to check settings.

Adjustable output from 5 to 80 W
One 18650 battery, not included
AXON chip and Pulse mode
0.96-inch TFT screen
USB-C charging at up to 2 A

Vaporesso GEN SE 80 W mod for an 18650 battery, photo of the model (variant Arctic Silver not shown)

€45.90incl. VAT

Checking availability…

Quantity

Price details and references

Price excl. VAT: €38.25
VAT: 20%

€45.90Arctic Silver

Description

A GEN SE powered by a separate battery

The Vaporesso GEN SE runs on an 18650 battery that is not included. Its adjustable output spans 5 to 80 W. This listing is for the mod without a tank, for users assembling a setup or replacing the power unit of their equipment.

The AXON chip and Pulse mode

The AXON electronics offer Pulse mode, which delivers power in pulses during a puff. The 0.96-inch TFT screen lets you view operating information. Always set the wattage according to the coil in use; the mod’s maximum output does not replace the limits specified for that coil.

Before keeping a setting, check it on the screen after installing a new coil. Start at the lower end of its recommended range, with properly saturated cotton. You can then increase the output in steps to suit the result you want.

Plan for battery charging

The USB-C port supports charging at up to 2 A. Use a power source suited to the manual’s instructions and check the connector’s condition. When replacing the battery, follow the polarity markings and inspect its insulation. Put any spare battery in a dedicated case before carrying it in a bag or pocket.