Lost Vape Ursa V3 replacement pods for Baby and Nano

Replace the pod on your Ursa

Lost Vape Ursa V3 pods replace the reservoir on Ursa Baby and Ursa Nano devices. This pack contains three. Each pod holds 2.5 ml of e-liquid and has its heating element built in, so you replace the complete assembly when the coil is worn.

Identify the selected resistance

The 0.6, 0.8 and 1.0 ohm versions let you keep the resistance that suits your setup. Read the marking on the removed pod to compare. If your device offers adjustable wattage, follow the instructions for the selected pod before its first use.

Prepare the cotton before vaping

Fill the reservoir through its dedicated opening, then close the silicone plug without leaving it crooked. With a new pod, wait at least five minutes after filling: this gives the liquid time to penetrate the cotton before heating.

At each replacement, check the device’s pod slot and dry any traces of liquid on the contacts. Verify that the plug is properly closed and the pod is correctly seated before using it again. Also watch the fill level so you can top it up before the cotton runs short of liquid.