Dotmod dotPod 2 ml replacement pods, pack of two

The 2 ml dotPod format

This Dotmod pack provides two dotPod replacement reservoirs. They have a 2 ml capacity and a built-in coil. This format works with devices including the dotPod Go. Check your device’s exact model before choosing a pod, even if it carries the Dotmod brand.

A coil that stays with the reservoir

In 0.6, 0.8 or 1.0 ohm versions, the coil is part of the pod and cannot be removed separately. Keep a note of your usual resistance if you want to retain the same setup. When the heating element wears out, replace the entire pod.

Top up through the side

Remove the reservoir from the device and open its silicone plug to reach the side filling port. Add e-liquid through this opening, then close the plug without pinching it. Check that no drops remain on the base before putting the pod back into the device.

For first use, allow the cotton to saturate after filling, following the manual’s recommendations. Between refills, watch the liquid level and wipe any condensation from the pod slot. Replace a reservoir with a crack or a damaged plug.