Geekvape Peak 4 ml replacement pods, pack of two

The Peak reservoir with its airflow control

This Geekvape pack contains two 4 ml pods for the Peak device. Each pod contains its coil. The reservoir fills from the top, while the airflow adjustment is underneath. These controls let you prepare the e-liquid and return to your airflow opening when replacing the pod.

Reach the top filling opening

Lift the protective lid, then open the silicone plug. Insert the bottle nozzle into the dedicated e-liquid opening. Fill slowly, put the plug back in place and close the lid. Wipe off any liquid left on the outside of the pod.

Adjust the air inlet

The dial beneath the pod changes the airflow opening. Note its position before fitting a new pod if you want a similar draw. Make small adjustments and check that the assembly is correctly installed.

After the first fill, allow time for the cotton to saturate before heating, according to the device’s manual. Do not activate an empty pod. When the built-in coil has reached the end of its life, replace the complete pod while keeping the body of your Peak.