Geekvape P Series Coils for Boost Pro, Five-Pack

Find the P Series for your Aegis Boost Pro

The Geekvape P Series coils in this pack are intended for the Aegis Boost Pro kit. The box contains five replacement heads. Before choosing a resistance, identify the full device name and the coil series already fitted: the word Boost alone does not replace this check.

Choose between P 0.4 and P 0.2 ohm

The P 0.4 ohm uses a setting between 50 and 60 W. The P 0.2 ohm requires 60 to 70 W. These ranges distinguish the two variants offered and give you the guidance to follow when adjusting your kit.

If you switch variants, read the value marked on the coil before activating it. Then set the power for this new part. Do not assume that the setting saved from the previous use suits the coil you have just fitted.

Prepare each replacement head

Wet the cotton in the new coil with your e-liquid, then allow it to soak after filling. The cotton must have absorbed the liquid before the first draw. Repeat this preparation whenever you replace a coil.

This consumable is intended for adults. Use is not recommended for pregnant women.