Vaporesso GTi Mesh - 5 Replacement Coils

GTi Mesh values for a direct draw

In Vaporesso’s iTank, the GTi Mesh coil is the replaceable heating component. This pack of 5 lets you renew that consumable while keeping the reference suited to your tank. The GTi family was developed for direct-to-lung inhalation.

Compare the power requirements

• 0.5 ohm: a 30 to 40 W range.
• 0.4 ohm: operation at 50 to 60 W.
• 0.2 ohm: settings from 60 to 75 W.
• 0.15 ohm: use at 75 to 90 W.

These differences matter when changing resistance values: your mod must be able to provide the corresponding power range. Do not automatically keep the setting used with your previous coil.

Opening and preparing the tank

Switch off the device, then replace the coil according to your iTank’s instructions. Use the opportunity to inspect the seals and remove any liquid from the contacts. Prime the coil with e-liquid, fill the tank and allow the cotton to absorb it before vaping. Afterwards, maintain enough liquid in the tank and stay within the limits printed on the coil.