Justfog Q16 Pro MTL kit with replaceable coil

The Q16 Pro pairs a 900 mAh box device with a 1.9 ml tank. Four voltage settings and an airflow ring let you adjust this mouth-to-lung setup.

Built-in 900 mAh battery
Top-fill 1.9 ml tank
Replaceable 1.6 ohm Series 14 coil
Four levels: 3.5 / 3.8 / 4.1 / 4.4 V
Airflow adjustment ring

Justfog Q16 Pro MTL kit with replaceable coil, photo of the model (variant Black not shown)

€24.90Black

A separate box device and tank

The Justfog Q16 Pro combines a built-in 900 mAh battery and a 1.9 ml tank for mouth-to-lung inhalation. A 1.6 ohm Series 14 coil comes with the kit. It can be replaced on its own, so the reservoir stays in use when the heating element wears out.

Choose one of four voltage levels

The lower button cycles through 3.5, 3.8, 4.1 and 4.4 V. The main button activates the heating element. Start at the lowest setting, then adjust gradually with the installed coil in mind. The ring at the tank’s base controls airflow separately, allowing you to tighten or open the draw.

Maintain the reservoir

To refill, unscrew the top cap. Pour liquid into an opening near the wall and keep the central air passage clear. To replace the coil, unscrew the base, then unscrew the coil attached to it.

Prime the cotton of a new coil and let it absorb liquid before heating. An indicator light shows the battery level; the box device recharges through its USB port. When reassembling, check that the coil and tank sections are properly screwed into place.

Brand: Justfog
Model: Q16 Pro
Battery: 900 mAh
Clearomizer: Q16 Pro, 1.9 ml
Included coil: 1.6 Ω
Other coil mentioned: 1.2 Ω
Power: four levels, about 15 W maximum
Airflow: adjustable
Charging: micro-USB

First setup

Install the coil in the clearomizer, then fill the tank from the top. Close it and let the cotton soak before any activation. Mount the clearomizer on the battery, then choose a power level suited to the coil. Adjust the airflow to get the indirect draw you want.

Charging and maintenance

Charge the battery via micro-USB as described in the manual. Check the e-liquid level regularly and clean the contacts whenever you take the device apart. If the flavor changes or the vapor drops despite a full tank, inspect the coil and replace it if needed.