Innokin Coolfire Z80 Kit with Zenith II

The Coolfire Z80 pairs an 80 W mod using a removable 18650 battery with the Z-Coil-compatible Zenith II. This setup lets you choose both your replacement coil and battery.

Up to 80 W output
One 18650 battery required, not included
Zenith II tank
Z-Coil compatibility
Adjustable airflow and top filling

Innokin Coolfire Z80 Kit with Zenith II, photo of the model (variant White not shown)

€54.90White

Description

A replaceable battery in the Coolfire Z80

This Innokin kit combines the Coolfire Z80 mod with the Zenith II tank. The mod delivers up to 80 W and uses one 18650 battery, purchased separately. A threaded cap opens the battery compartment, allowing you to remove the cell without replacing the mod. A USB-C port is also fitted.

Zenith II and the Z-Coil range

The tank accepts Innokin Z-Coils. This configuration lists 0.8 and 0.3 ohm options. Set the output for the coil you have installed and stay within the range marked on it; the mod’s maximum output is not the setting to use with every coil.

The airflow ring at the bottom changes the draw. To add liquid, rotate the Zenith II top cap to expose the filling opening. Close it again after filling, and let a new coil absorb liquid before using it.

Prepare your equipment before leaving

Check the condition of the battery sleeve and follow the polarity markings inside the compartment. If you carry a spare cell, keep it in an insulating case away from metal objects. These checks apply whenever you swap the removable battery.

This equipment is intended for adults.